# Step-by-Step toilet replacement guide

**URL:** <https://home.renovation.reviews/t/step-by-step-toilet-replacement-guide/21290>\
**Category:** DIY & Tutorials\
**Created:** [August 20, 2025, 7:43am UTC](https://home.renovation.reviews/t/step-by-step-toilet-replacement-guide/21290 "2025-08-20T07:43:28Z")\
**Posts on this page:** 8\
**Page:** 1

<div class="post-metadata">

**Author:** ![Asher](https://home.renovation.reviews/user_avatar/home.renovation.reviews/asher/32/2057_2.png) [@Asher](https://home.renovation.reviews/u/Asher)\
**Post date:** [August 20, 2025, 7:43am UTC](https://home.renovation.reviews/t/step-by-step-toilet-replacement-guide/21290/1 "2025-08-20T07:43:28Z")

</div>

## Tools & Materials

Adjustable wrench, bucket & sponge/towels, utility knife, flat putty knife, hacksaw (if bolts are stuck), new closet bolts, new wax ring **or** wax-free seal, optional shims, new braided supply hose, caulk & caulk gun, gloves.

* * *

### 1) Shut Off & Drain

- Turn the shutoff valve clockwise.

- Flush to empty the tank and bowl. Sponge out remaining water into a bucket.

### 2) Disconnect Water

- Unscrew the supply hose from the tank (keep the bucket under it).

### 3) Remove the Old Toilet

- Pop the bolt caps at the base; loosen nuts. If corroded, cut bolts with a hacksaw.

- If it’s a two-piece toilet, lift the **tank** off first (two bolts underneath), then the **bowl**.

- Gently rock the bowl to break the wax seal and lift it straight up.

- **Stuff a rag in the drain** to block sewer gas and dropped hardware.

### 4) Clean & Inspect the Flange

- Scrape off all old wax with a putty knife.

- Check the flange: replace broken closet bolts; use a repair ring if cracked or not level.

### 5) Dry-Fit & Level

- Set the new bowl in place **without** the seal to check alignment and see if shims are needed. Mark positions. Lift it back off.

- Place new closet bolts in the flange slots at 3 and 9 o’clock.

### 6) Set the Seal

- Press a new wax ring (or wax-free seal) onto the bowl outlet (“horn”).  
_Tip: Warm wax slightly for better compression._

### 7) Set the Bowl

- **Remove the rag from the drain.**

- Lower the bowl straight down, guiding bolts through the holes. Sit and press firmly to compress the seal—don’t twist.

- Insert shims as needed to eliminate wobble.

### 8) Secure the Bowl

- Add washers/nuts and tighten **alternately, a little at a time** until snug. Don’t over-tighten (porcelain can crack). Trim bolt excess; snap on caps.

### 9) Install the Tank (for two-piece models)

- Fit the tank-to-bowl gasket, set the tank, insert bolts with rubber washers inside the tank, and tighten evenly until stable (hand-snug + a bit).

### 10) Connect Water

- Attach a **new** braided supply hose from valve to tank. Open the valve slowly and let the tank fill.

### 11) Test & Tweak

- Flush several times. Check for leaks at: base, supply connections, and tank bolts. Slightly tighten if needed.

- If you must lift the bowl again, **use a brand-new wax ring** —never reuse.

### 12) Caulk & Finish

- Run a bead of caulk around the base **leaving a small gap at the back** (leak detection).

- Install the seat and tidy up.

* * *

## In Conclusion

Replacing a toilet is more about patience than muscle: shut off water, keep things clean and level, and tighten gently. With a fresh seal, solid bolts, and careful leak checks, you’ll have a rock-steady, drip-free toilet that looks and works like new—plus the quiet pride of knowing you did it yourself.

 ![c5888e2e127b717e859c24e53e7e9fad](https://renovation-reviews.storage.googleapis.com/original/2X/2/22649a54836fa896d5ee69aa56d3078d6cb06e18.jpeg)

et pride of knowing you did it yourself.

---

<div class="post-metadata">

**Author:** ![Theodore\_3456](https://home.renovation.reviews/user_avatar/home.renovation.reviews/theodore_3456/32/2821_2.png) [@Theodore\_3456](https://home.renovation.reviews/u/Theodore_3456)\
**Post date:** [August 20, 2025, 7:44am UTC](https://home.renovation.reviews/t/step-by-step-toilet-replacement-guide/21290/2 "2025-08-20T07:44:06Z")

</div>

Need to save this tutorial guide for later 😄

---

<div class="post-metadata">

**Author:** ![Tim\_Michael1](https://home.renovation.reviews/user_avatar/home.renovation.reviews/tim_michael1/32/6294_2.png) [@Tim\_Michael1](https://home.renovation.reviews/u/Tim_Michael1)\
**Post date:** [August 20, 2025, 7:45am UTC](https://home.renovation.reviews/t/step-by-step-toilet-replacement-guide/21290/3 "2025-08-20T07:45:22Z")

</div>

I feel like sleeping on it

---

<div class="post-metadata">

**Author:** ![Joyboy03j](https://home.renovation.reviews/user_avatar/home.renovation.reviews/joyboy03j/32/2900_2.png) [@Joyboy03j](https://home.renovation.reviews/u/Joyboy03j)\
**Post date:** [August 20, 2025, 9:46am UTC](https://home.renovation.reviews/t/step-by-step-toilet-replacement-guide/21290/4 "2025-08-20T09:46:51Z")

</div>

Hehehe can I put the work to this 😆

---

<div class="post-metadata">

**Author:** ![Lexi\_Carter1](https://home.renovation.reviews/user_avatar/home.renovation.reviews/lexi_carter1/32/2767_2.png) [@Lexi\_Carter1](https://home.renovation.reviews/u/Lexi_Carter1)\
**Post date:** [August 20, 2025, 9:55am UTC](https://home.renovation.reviews/t/step-by-step-toilet-replacement-guide/21290/5 "2025-08-20T09:55:21Z")

</div>

Love the guide put out .

---

<div class="post-metadata">

**Author:** ![Michelle\_Brown](https://home.renovation.reviews/user_avatar/home.renovation.reviews/michelle_brown/32/2325_2.png) [@Michelle\_Brown](https://home.renovation.reviews/u/Michelle_Brown)\
**Post date:** [August 20, 2025, 10:21am UTC](https://home.renovation.reviews/t/step-by-step-toilet-replacement-guide/21290/6 "2025-08-20T10:21:20Z")

</div>

This is very much helpful

---

<div class="post-metadata">

**Author:** ![Bobby\_Michael](https://home.renovation.reviews/user_avatar/home.renovation.reviews/bobby_michael/32/2057_2.png) [@Bobby\_Michael](https://home.renovation.reviews/u/Bobby_Michael)\
**Post date:** [August 20, 2025, 10:23am UTC](https://home.renovation.reviews/t/step-by-step-toilet-replacement-guide/21290/7 "2025-08-20T10:23:03Z")

</div>

Words won’t be enough to explain how grateful I am towards this write up, like everything’s in place and well explained

Thanks a lot mate, keep it going

---

<div class="post-metadata">

**Author:** ![MichaelRobert](https://home.renovation.reviews/letter_avatar_proxy/v4/letter/m/da6949/32.png) [@MichaelRobert](https://home.renovation.reviews/u/MichaelRobert)\
**Post date:** [September 11, 2025, 12:34am UTC](https://home.renovation.reviews/t/step-by-step-toilet-replacement-guide/21290/8 "2025-09-11T00:34:53Z")

</div>

will be back in time
