# Replaced all six bathroom exhaust fans in our Mississauga house: ESA permit, costs, and HRV notes

**URL:** <https://home.renovation.reviews/t/replaced-all-six-bathroom-exhaust-fans-in-our-mississauga-house-esa-permit-costs-and-hrv-notes/46802>\
**Category:** DIY & Tutorials\
**Created:** [April 26, 2026, 5:17pm UTC](https://home.renovation.reviews/t/replaced-all-six-bathroom-exhaust-fans-in-our-mississauga-house-esa-permit-costs-and-hrv-notes/46802 "2026-04-26T17:17:46Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![system](https://home.renovation.reviews/user_avatar/home.renovation.reviews/system/32/77_2.png) [@system](https://home.renovation.reviews/u/system)\
**Post date:** [April 26, 2026, 5:17pm UTC](https://home.renovation.reviews/t/replaced-all-six-bathroom-exhaust-fans-in-our-mississauga-house-esa-permit-costs-and-hrv-notes/46802/1 "2026-04-26T17:17:46Z")

</div>

Our Mississauga house was built in 1996 and had the original 60-CFM fans in every bathroom. After a mould issue in the main floor powder room (turns out the fan was venting into the ceiling cavity — not to exterior), we decided to replace all six at once.

**Scope:** 4 full bathrooms, 2 powder rooms. All fans replaced with Panasonic WhisperCeiling 110 CFM units. All ducts inspected and in three bathrooms re-routed to proper exterior wall caps.

**The disaster we found:** Two of the six fans were venting into the attic. This is both a code violation and the cause of our mould. The attic insulation around those duct terminations was black and had to be replaced. Add $800 to the project.

**Electrician scope:** Our house has an HRV (Carrier) installed in 2018. The electrician tied the new fans into the HRV controller so they can operate in coordination. Three of the six powder/bath fans now have 20-minute timers that trigger the HRV boost mode. This is proper Ontario practice for airtight houses.

**Permits:** ESA permit required for any new circuit. Two bathrooms needed new dedicated circuits (the powder rooms were on shared circuits). Permit and inspection: $340.

**Total costs:**

- 6x Panasonic 110 CFM fans: $1,140 (supply)
- Electrician (labour, 2 new circuits, HRV wiring): $1,880
- Sheet metal re-routing 3 duct runs: $920
- Attic mould remediation and insulation patch: $800
- Drywall patches x4: $640
- Permits: $340
- **Total: $5,720**

Every bathroom now clears steam in under 4 minutes. The mould is gone. Should have done this 10 years ago.
